Everytime when someone hacks his machine, a new machine is been created. So, the hacked machines below are in reality new machines. (In development.) On this moment, November 2007, i own 8 Amiga computers. 3 machines for parts and 5 machines for to work with and for to rebuilt. The first (hacked) Amiga as a reaction on the CBM triple A project is an Amiga 500R5 Kick V34 computer. This Amiga contains 2 MB of FastRAM, a half of MB (hardware) RAD in SlowRAM and 0.5 MB normal slowRAM. The Amiga owns only 0.5 MB of ChipRAM which is in use as DMA for the Custom processors. The Blitters are build in FastRAM. ( Via Fblit ) But the Machine owns also 24 bits Video RAM card below the denise. With smartcache software on the A590 HD controller, with 20 MB HD, this machine is even so fast as an Amiga 1200 computer with copro's on board. Pictures are stored within the video ram. This works fine with DigiPaint, DluxePaint and PhotonPaint programs. On this machine CBM developer Arexx, AmigaGuide and CBM-installer is running. With this machine i can use a part of kickstart 2.0 and WB 2.1 software. For the next years for this Amiga becomes: 24 bits SVHS digital and analogue outputs. And a Genlock. For the far future, i will remove the permanent chips of the ChipRAM. For adding a memory header or something in that mind. For to expand the ChipRAM. And for a easy replacement of the internal A500 memory. An another CBM Amiga 500 Revision 6A is waiting for a 2 MB HR Agnus and for a ChipRAM replacement. Not 4 x 256 * 4 bits, but 8 x 1M * 4 bits. The keyboard and mouse will be replaced by a USB 1.0 connection. I have already been tested the Amiga for to run on solarpower with a power controller inbetween and a 45 AH battery. The orginal RGB will be replaced by a more modern video output connection. The next hacked Amiga is a CBM Amiga 1200 R1D machine, with on the internal IDE port a chip(disk) in place of harddisk. The Amiga with a Blizzard 1230 50 Mhz card (+SCSI-2) installed is faster then a 2 GHz Wintel machine. I have added 70 Nano secs SIMMS to it, but i have removed all jumpers. It makes the turbocard faster as a 68060 card! ( It is a hack. ) The only delay during the booting up is caused by the selftest of the Amiga kickstart during the bootprocess. But if the bootprocess starts from chip, within a few seconds the Workbench is ready for to use. The chip can be installed via the normal AmigaDOS install software. No Extra drivers are needed. The chip has a very low energy consumption. With this the Amiga own 23 Watt PSU installed. ( The chip consumes somewhere around the 50 mAh. ( 0.05 Ah ) There are for the rest no delays within the hardware. On the chip there are two partitions: One is the Workbench and the other is Work. The third hacked machine is a CBM Amiga 2000 R4.4 computer. Installed, kickstart 2.05. 6 MB 24 bits RAM, 1 MB ChipRAM, 1,5 MB Video RAM an 68030 CPU and 68882 FPU and MMU on 25 MHz. 0,5 MB Vlab Y/C video digitizer and a Genlock and Encoder on the Amiga 2000 video slot. Software utilities are memtrailer and fasterforbid, which shortens the forbidden commands within the Amiga control process. Memtrailer prevents the Amiga against illegal memory calls. This machine is faster then any Wintel machine. In the nearby future Chips will replace the harddisks within this Amiga. And in the meanwhile i'am searching over the internet for to find something about to connect the Amiga SCSI-2 to a fast USB 2.0 or firewire I/O. But this is future stuff. In storage i have a CBM Amiga 600 computer, but i haven't yet to see what i can do with this machine. But if i find some improvements for this machine, i will include it to this textfile. With regards Jacqueline Mols.